![]() ![]() Maximum Pour Depth per Layer: 2" for river pours and slab pours 3" for larger castings using less than 1 gallon of mixed epoxy. When applying to wood or porous surfaces, be sure to apply a very thin skim coat of epoxy to seal the surface, and allow it to cure before applying more epoxy. ![]() When pouring for larger projects, such as slabs or tables, do not exceed a pour depth of 2" to prevent yellowing or excessive heat from the cure. For the epoxy to cure fully, the ambient temperature must be between 60☏ and 80☏. Helping to dissipate the heat may help promote the best results. Depending on the mass of mixed epoxy used in a single pour, the pour depth, and the ambient temperature, excessive heat may build up from the reaction, causing potential yellowing, cracks, or other shrinkage. IMPORTANT! Environmental conditions are extremely important to the clarity and quality of the cure. But, if you are pouring deeper than an inch per layer, you want Fathom!Īpplication Temperature/RH: 60-80☏, relative humidity 0-80% TotalBoat ThickSet and ThickSet Fathom epoxies are both deep epoxies. Should I use TotalBoat ThickSet or ThickSet Fathom epoxy for my project – what’s the difference? Always follow the maximum pour depth based on the volume of ThickSet Fathom.Wait until the previous layer has dropped below 85☏, and the previous epoxy pour has firmed up enough that it will not distort when liquid epoxy is poured on it - it is likely that the previous layer will still be soft.For applications when it’s important to have the shortest interval for multiple pours, wait at least 24 hours, then use an infrared thermometer to measure the temperature at the center of the epoxy mass, where the highest temperature will be recorded.Conservatively, the safest interval to wait is a minimum of 36 hours for ThickSet Fathom to cure prior to applying more, regardless of pour depth and ambient temperature.When your project involves pouring multiple layers of ThickSet Fathom, it is extremely important to wait until the previous layer has cooled sufficiently, to prevent surface distortion, yellowing, or other negative effects of excessive heat while the epoxy is curing.Not compatible with 2:1 epoxy pumps.įor best results when applying additional layers of ThickSet Fathom after the first pour, it’s important to note the following: Do not use in working temperatures above 80☏. PLEASE NOTE: ThickSet Fathom is an advanced deep pour epoxy resin system.Kit sizes: 1.5 Gallon Kit, 3 Gallon Kit, and 6 Gallon Kit.Use on prepared wood, concrete, metal, and stone surfaces to make unique table, counter and bar tops.Low VOC and low odor make it ideal for indoor or studio use.Self-leveling formula releases bubbles easily.Easy to tint resin with mica powder, alcohol inks, universal tints and pigment paste dispersions.Simple 2:1 ratio makes it easy to mix and apply.Ultra-clear, high-gloss finish resists scratches, stains and yellowing.Extremely slow cure time allows thick pours up to three times deeper than traditional epoxy systems. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |